Flare Ignition Device Used For Oil/gas Drilling And Methane Flare System

April 26, 2010 - PRLog -- GN solids control produce flare ignition device matched with mud gas separator (poor boy degasser). They are used together to process the combustible gas. But it can also used for and Methane flare system, it can used together with the Methane pipe.

http://www.gnsolidscontrol.com/electric-ignition-device/

Flares are used to safely dispose of combustible gas and avoid releasing it to the atmosphere. Some flares have one or more continuously burning pilot flames, while others save gas by only igniting pilot flames in preparation for use. Pilots can be blown out by wind and gas leakage and/or waste gas is occasionally released to an unlit flare. Both of these situations result in methane, volatile organic compounds (VOC) and hazardous air pollutant (HAP) emissions to the atmosphere. This technology replaces the intermittently or continuously burning flare pilots with electrical sparking pilots similar to a modern gas stove. These sparking pilots require low electrical power that can be supplied from a battery with solar recharge in remote sites. In addition to using electronic flare ignition devices for pilots, facilities may also install sensors to detect the pilot flame and shut off fuel gas if the pilot is extinguished. Operating Requirements A low amperage electrical power supply is required, such as solar recharged batteries. Applicability This technology can be applied to all pilot flame ignition systems, including flares and heaters.

http://oilfield.gnsolidscontrol.com/oilfield-flare-ignito...

Methane Emissions Reductions

Methane emissions occur from leaking or venting un-combusted natural gas through an unlit flare. Leakage may occur through emergency relief valves and blowdown valves connected to a flare. Venting occurs when flare pilot flames are occasionally blown out by high winds, causing release of methane at 70 scf per hour per pilot until they are relit or shut off.

If you need it to be used as Methane flare system, we should know the pipe pressure and pipe diameter, then we will design the ignition device according to your requirement.

http://www.gn-desander-desilter.com/

It has been widely used in oil/gas drilling at site and the quality is proved from the client’s feedback. For more information of flare ignition device, pls contact GN solids control.

# # #

GN-Solids control is a China solids control equipments professional manufacturer.Our solids control equipments can be used in both onshore and offshore oilfield for oil gas well drilling fluids circulation-Drilling mud complete solids control.