Plan To Recondition Or Refresh Your Power Tools Batteries?

June 25, 2010 - PRLog -- Power tools batteries are typically nickel cadmium rechargeable batteries

Power tools use batteries or electricity to function, and batteries can be rechargeable or for one-time use. Typically, they are rechargeable. Nickel cadmium, or NiCd batteries, are normally used in power tools. These can be charged up to around 1,000 times before they need replacing. Reconditioning, especially after months of no use, is very good for these batteries, and should be done about once a month throughout battery life to ensure proper functioning and optimal lifespan.

Instructions

Run the battery in the power tool without any obstruction. For instance, if you have a power drill, run the drill by itself, do not try to drill in anything; just let the battery run until it’s dead.
Plug the power tools battery charger into the electrical outlet.
Charge the battery back to full capacity.
Run the battery as before until it is dead again.
Recharge the battery again.
Repeat once a month, or if this process has not improved your battery’s performance, throw that one away and purchase a new one.

High quality power tools batteries, cordless drill batteries here:
http://www.g-batteryshop.com/power-tools-battery.htm
*****************************************************************
How to Refresh Power Tool Batteries

Power tool batteries that are rechargeable can develop a memory if they aren’t used often or used to their full charge. Once a battery develops memory it can seem to be fully charged but when you use the tool, the battery will be dead within a few minutes. This is an annoying feature of rechargable power tool batteries that you can fix in just a few days with a couple of simple steps.

Instructions

Hook the battery to the power tool and use the tool, or run the tool until the battery goes completely dead. Then leave it attached to the tool overnight.
Run the tool with the battery in the morning. If it will run the tool, use it until it goes completely dead. By doing this, you are essentially erasing the memory in the battery and deleting the false empty cycle of the battery.
Place the battery on the charge only when it will not power the tool at all. Let it charge fully, which should take overnight.
Run the tool with the battery attached until it is again completely dead. Don’t charge the battery again until it’s completely dead.
Repeat the charge and drain process several times, and the battery will get better at holding a charge and charging completely.

for details here:

http://www.pioneer-electronics.co.uk/plan-to-recondition-...

# # #

http://www.pioneer-electronics.co.uk/ -- Cheap laptop batteries, laptop ac adapters and laptop dc adapters for UK Laptop users,including Dell laptop batteries, Toshiba laptop batteries etc.
High Quality & Superb Service, season promotion, 30% discount!