 Tainted Corrosive Chinese Drywall-NDE Protocol-SNiPER®Treatment-XRF-Wiring-CPSC-NAHB-Chamber TestsMedia, Lawyers, Manufacturers, Developers, Contractors, Government Agency's, and our Legal System, reference, detail, note, document, and quote information, assuming Consumers know the full scope, definition, meaning and application of the terms used
By: Michael S. Foreman April 24, 2011 - PRLog -- Chinese Drywall (CDW) or Tainted and Corrosive Drywall (TCDW) structures require construction abatement activities, performed per specific protocols and treatment systems, eliminating and eradicating not only existing TCDW out-gassing issues, but also future unknown residual out-gassing issues.
Health issues and future unknown Health issues from TCDW vapor exposure, both long and short term are unknown at this time, and will require extensive future testing, per recent CDC Press Releases will not be funded or performed. We start with a recap of information and facts - TO-DATE 1) Diagnosis ... NDE Protocol Confirming and validating the structure is infected, by NDE Visual Analysis or Inspection, per approved protocols or systems. NDE Visual Analysis is the best and most accurate means and method to confirm and validate CDW or TCDW structures ... PERIOD !!! Visit ... http://www.constructionguru.com/ established January 2009, confirmed and validated in the field, with over 600 individual residence / structure analysis, released to the Consumer, February 1st, 2011. ASTM Emergency Work Group has failed to produce an NDE Analysis or Testing Standard since inception of the Work Group, November 2009, further confirming ASTM Managements, Emergency Work Group Status ... persona non-grata. 2) Abatement ... Corrective Re-Work Removal of all electrical, copper plumbing, HVAC, HVAC duct work, insulation, drywall, wood trim, wood doors, carpet / pad, cabinets, counter tops, ceiling fans, and other wood or porous components, basically stripping the structure back to PRE-ROUGH-IN structural metal framing, structural wood framing, concrete masonry block, windows, exterior doors and / or other components. Numerous conflicting, inaccurate, misleading, and questionable CPSC Reports have resulted with chaos and a loss of Consumer Confidence with the CPSC. Up-Date ... http://prlog.org/ 3) Treatment ... Non-Toxic / Non-Voc product application Based on simple facts, not opinions ... at this time ... NO ONE or NO GOVERNMENT AGENCY has determined the specific cause(s), with-in the drywall, creating the corrosive out-gassing vapors, or even acceptable out-gassing levels per ASTM Standards pertaining to Residential Construction. With that thought, I have strongly encouraged our clients pay for a SNiPER® Treatment Application System that neutralizes known out-gassing vapors that permeate or absorb into the remaining construction materials after the abatement process. Post Treatment ASTM Chamber Testing of remaining construction material samples, collected after Treatment System application, further confirm and validate Treatment success. Treatment Application System, not only eliminates and eradicates hydrogen sulfide and other out-gassing vapor(s) / residue(s), but also kills mold and mildew on contact, found in most structures during the Abatement Phase. Treatment Application Product is Eco-Friendly, Non-Voc, safe, EPA Registered and results with an Insurance Policy after SNiPER® http://www.youtube.com/ 4) XRF Technology Numerous so called ... Scientific ... groups, individuals, and companies have promoted XRF Technology to identify, confirm, and misclassified CDW or TCDW, based on ... Junk Science ... without confirmed and documented lab or field testing ... assuming STRONTIUM was a marker for CDW or TCDW. http://prlog.org/ Consumers, Lenders, Insurers, Lawyers, and others looking for answers, cost effective diagnosis methods, cost effective abatement resolutions, abatement decisions, purchase decisions, and legal theories based on XRF ... Junk Science ... need to seriously review and re-evaluate their actions, decisions, concepts, and legal theories based on CPSC, HUD, EPA, and CDC Federal Task Group Reports dated 8-27-2010 and 1-3-2011 . http://www.cpsc.gov/ http://ecologic.typepad.com/ 5) CDW or TCDW Certifications Consumers now know, there are no CDW or TCDW College Degrees, College classes, or Certifications ... APPROVED by ASTM, OSHA, EPA, or any other accredited State Licensed College or Licensed Federal Educational Institution. ASTM 1396 / C 1396M section 4.1 ... Clearly confirms and validates the gypsum or sheet- DEFECTIVE ... ASTM 1396 Materials and Manufacture ... Section 4.1 states ... "GYPSUM BOARD SHALL CONSIST OF A NONCOMBUSTIBLE CORE, ESSENTIALLY GYPSUM, SURFACED WITH PAPER BONDED TO THE CORE." Key words ... ESSENTIALLY GYPSUM ... results in all sheet-rock, meeting the standard. Clearly ... this is why the CPSC, OSHA, EPA, HUD or any other Government Agency has NOT ... TO-DATE ... issued or demanded a ... RE-CALL ... on the product. 6) Post Treatment or Post Abatement Testing After Abatement or Treatment Testing required per Judge Fallon's guidelines, Fails to provide specific testing means and methods, ASTM Type Test, specific acceptable threshold level of out-gassing, or even specific out-gassing element(s) or material(s) to be tested. Fallon's guidelines simply require a Clearance Letter or documents from a Licensed Hygienist or Environmental Engineer, leaving a lot for interpretation, abuse, or opinion. We recommend and request Clearance Documents based on third party ASTM Chamber Testing of sample construction materials, acquired after SNiPER® Treatment Application and even further ASTM Chamber Testing, of samples per batch number of NEW sheet-rock material, prior to installation, confirming acceptable out-gassing levels. 7) Personal Property Treatment Treatment of personal property before relocation is important and may require re- treatment prior to occupancy of re-constructed structure to avoid cross-contamination. SNiPER® Treatment Application avoids costly disposal of numerous items, avoiding re- placement cost, and helping control total re-construction and re-location cost. Consumers, Homeowners, Lenders, Insurers, Lawyers, and others looking for more answers or information concerning specific questions: E-Mail or call 941-955-8111, and a CONSUMER ADVOCATE CONSULTANT, will honestly answer your questions, others either do not know or can not answer. Follow our NDE Protocol, NOW AVAILABLE, complements of Foreman and Associates, avoiding unnecessary or misleading classes or certifications for a fee. Foreman and Associates, Inc. is the CDW or TCDW Industry Leader with numerous documented and published articles, statements, and facts. Thank you for your time and our Firm hopes our information has been educational, help-full and use-full. Educating and Empowering Consumers for over 10 years. Michael S. Foreman Forensic Construction Consultant Consumer Advocate http://www.ConstructionGuru.com # # # Foreman and Associates, a FULL service forensic construction consulting firm. Our firms Treatment Protocol for Tainted Corrosive Drywall commonly called Chinese Drywall has been validated, confirmed, tested, and documented as 100% successful. Our firms SNiPER® Treatment Application Protocol affords Consumers the option of a Chinese Drywall Specific Insurance Policy, covering any future issues associated with not only Chinese Drywall or Tainted Corrosive Drywall, but also the future unknown out-gassing vapor residual issues End
Page Updated Last on: Jan 10, 2012
|
Account Phone Number