LED Auto 3D Logo Laser Lights for Different Brands,Custom Logo Available!

JIAXING, China - April 22, 2013 - PRLog -- More than 200 different logo options,custom logo design is acceptable,you can have your own DIY logos!!!

1 set includes:2 pieces of LED logo projectors and 1 piece of installation drill.


This LED Door Lights can be automaticlly on when car doors open.

Outpower:3W/5W

Voltage:12V/24V

Working Temp:-40 degrees~ 105 degrees

Material:Aluminium alloy casing

Life span:30,000-50,000 hours

Certification:E4 / RDW


Installation:

This LED lights can be installed at the bottom of the door flame and make sure the Len vertical with the ground ;

1. Pull down the inside door board first. Mark the suitable location for drilling a hole.

2. Drill the hole on the door board with our borer .

3. Inset the product from the bottom of car door ,then arrange the power cord.

4. Install the nut through the power cord upon the hole inside; Tighten the nut;

5. Connect the power cord according to the installation guide;

6. Adjust the lamp projection to the suitable place with wrench tool.

7. Reinstall the inside door board,then check the final effect.