HP Printer error code 59.F0 | HP

NEW YORK - March 9, 2021 - PRLog -- Causes behind HP printer Error Code 59.F0 (https://www.itphoneservice.com/services/common-printer-error/common-hp-printer-error-codes/hp-printer-error-59.f0/)
The error mainly takes place because of problems associated with the inside motor of the printer. Also, the other reason behind this error is that the failure of transfer alienation. It means a situation where the ITB is stuck and can't rotate.

Read More : HP printer Error Code 59.F0 (https://www.itphoneservice.com/services/common-printer-error/common-hp-printer-error-codes/hp-printer-error-59.f0/)

Now, moving towards, the solutions, Here they are:

Solution 1: Reset the printer
The first step is that you simply simply got to activate your HP printer.
Carefully, disconnect all the power cables connected to the rear a neighborhood of your printer. Also, stop the power supply.
You have to attend for 30 seconds a minimum of before plugging back all the wires into the printer. And, don't forget to connect the power supply sources also .
You will notice that your HP printer activate automatically as you haven't turned it off before unplugging all the cables.

Read More : HP printer Error Code 59.F0 (https://www.itphoneservice.com/services/common-printer-er...)

Solution 2: Reset the ITB
You have to reset the ITB manually.
After that, you've to ascertain for the inside connections of ITB like connections between the ITB and a transfer roller disengagement sensor located at connector J19.
Also, check the connection between the ITB and DC controller PCA also mentioned as connector J128.

Read More : HP printer Error Code 59.F0 (https://www.itphoneservice.com/services/common-printer-error/common-hp-printer-error-codes/hp-printer-error-59.f0/)

Solution 3: Test the ITB
Since the error remains present, first you've to urge obviate the ITB completely then test the ITB gear and thus the flag manually..

Here are the steps to perform this task:

The first step is to rotate the gear and check for any fluctuations within the flag once you switch the white gear.
And if the flag is found to be damaged then it's peak time that you simply simply got to remove the ITB and place a replacement one.
But the question is what if the flag and thus the ITB gear are working perfectly

First, you've to urge obviate the ITB gear, locate the sensor SR9 locate inside the ITB cavity. Browse the control panel .

Source : HP printer Error Code 59.F0 (https://www.itphoneservice.com/services/common-printer-error/common-hp-printer-error-codes/hp-printer-error-59.f0/)