How to test and install solar beam system

ATLANTIC BEACH, Fla. - Sept. 13, 2021 - PRLog -- Solar beam wireless perimeter security system is popular used for security protection of factory, community, warehouse, villa etc. It is easy to install without any wiring. It is easy to maintenance with fault, low battery report and tamper-resistant. It is easy to be added to exist security system with wireless signal adapter. It is easy to use with CMS security service management software.
How to test and install the solar beam system?
1. Test Method
To test the quality of wireless solar powered alarm beams, we should test 4 parts of the system. They are battery, infrared distance, wireless signal transmitting distance and solar panel charging capability at cloudy and rainy days.
A. Test of battery
The rate voltage of the battery is 4.2V. If the solar powered wireless beam works at illumination under 1600Lx for continual days and the battery voltage is down to 3.8V, the product will activate battery protection system.

Test 1:
Working time without sunlight
The solar powered beams can work for 20 days without sunlight.
Put the beams with battery installed at place without illumination such as drawer, box, then trigger it. The day before receiver terminal indicator doesn't light on is the last work day.
Test 2:
Battery recharging time
At normal sunlight environment, the battery recharging time is 1 day. (from low voltage to full voltage)
Put the beam with battery installed at place full of sunlight, take down the battery and test its voltage after 1 day.
B. Test of infrared distance
The infrared distance of wireless solar powered beams is 100m
Install the batteries in beams, aiming and then enroll it to alarm panel. Take the transmitter and receiver beams to 100m distance, aiming again, receiver terminal indicator flash slow then flash fast and then light off. Trigger the beams, the alarm panel send out alarm signal.
C. Test of wireless transmitting distance
The distance between wireless beams and alarm panel is 100m (can reach to 1 km with high power)
Put the alarm panel at a place, enroll the wireless beams to the panel, put the beams at another place which is 100m from the panel, trigger the beams, the panel will alarm. Repeat to trigger the beams to test the stability.
D. Test of solar panel charging capability at bad days
Amorphous silicon solar panel is used for the beams. It enables the beams to be recharged at cloudy and rainy days.

Notes of using the solar powered wireless beams (https://vedardalarm.com/hb-solar-beams-m-3)
1. Trigger way

2. Aiming