Linear motion mud cleaner maintenance

July 30, 2011 - PRLog -- GN linear motion mud cleaner is used mainly for oilfield drilling and horizontal directional drilling mud system. The hydrocyclone is optional according to specific requirement. GN solids control is specialist for linear motion mud cleaner in China.

Following is some suggestions about mud cleaner maintenance.
http://www.gnsolidscontrol.com/mud-cleaner/

Firstly review the main components of mud cleaner: underflow shaker, desander cone(10”), desilter cone(4”), mud cleaner frame, inlet pipe, outlet pipe, collection box and pressure gauge.

1 desander and desilter cone maintenance

The 4” hydrocyclone desilter removes 10- to 74-micron solids from drilling fluid (mud), and the 10” hydrocyclone desander is used to separate solids in the 40- to 100-micron range, The body is the main component of the 4” hydrocyclone. A cone tip is threaded into the bottom of the body. The soft apex is positioned in the tapered hole inside the triangular nut, which is threaded onto the cone tip.

http://oilfield.gnsolidscontrol.com/drilling-mud-cleaning...

The 10” desander consists of three main components: Upper, middle, and lower sections. The soft orifice bushing (apex) is positioned in the tapered hole inside the orifice nut, which is threaded onto the lower section. The orifice nut is threaded onto the lower section.

Desilter Connections

All desilters have inlet and discharge pipes designed to accept Victaulic couplings .The inlet connection is on top of the unit, and two horizontal discharge connections are provided. Either or both discharge connection(s) may be used to accommodate the customer piping arrangement. For single inlet piping, the unused connection must be capped.

Desander Connections

http://oilfield.gnsolidscontrol.com/shale-shaker-operatio...

The 10” desander has horizontal inlet and discharge pipes, which are also designed for Victaulic couplers. The inlet connection (lower pipe) is 8”, and discharge (upper pipe) is 10”. Customer piping may be connected to either desander inlet pipe. However, the discharge pipe may be connected only to the left side of the discharge manifold, as viewed from the feed end of the machine and looking toward the discharge end; the right side is sealed.

For more info about linear motion mud cleaner, pls contact GN solids control.

# # #

GN provides you qualified goods at your budget. including shale shaker, mud cleaner, decanter centrifuge, centrifugal pump, decanter centrifuge, mud agitator, mud jet mixer, mud gas separator, flare ignition device, whole mud purification sytem