Concrete Cutting Sydney – Methods and Tips

PEAKHURST, Australia - Oct. 13, 2021 - PRLog -- Concrete cutting is not just a complex job, but it can also be hazardous if you don't approach it with the right mindset and preparation. Whether you are drilling or sawing through concrete, you must understand the basics of how to do it right.

Methods

There are several different concrete cutting methods. Some of the primary and most commonly used methods include the following:

• Diamond Sawing: Diamond saws are efficient; they are ideal for more precise cuts and run faster. They are also very silent and can easily cut through most types of materials, e.g. rebar.
• Flat Sawing: Pavements, floors, and such surfaces will require you to use this method.
• Core Drilling: This method opens up spaces in floors and walls for air vents, electrical wires, and pipes.
• Wire Sawing: Wire sawing is ideal for more intense concrete cutting tasks where most other methods fail.
• Concrete Wall Sawing: For cutting into concrete walls, circular blades set into a track are an ideal choice.

Tools Required

Depending on your specific requirement for concrete cutting Sydney, you will need to use a wall saw, a flat saw, or a wire saw. While holding any of these tools, it is recommended that you proceed with caution. These tools will have blades or wheels as their cutting mechanism. They are all engine-powered and feature hydraulics to increase their power of cutting.

Procedure

Start by figuring out which parts of the concrete need to be cut first. It is recommended that you mark those areas as it will make your job much easier. Next, use a hand saw to make your first cut. Handsaws are ideal for making about four inches deep cuts. If you need to cut more profound than this, you will need to use a concrete cutting machine instead. Make sure to cut as far as you require without making the cuts too shallow or going too far in.

Apart from this, concrete cutting services also recommended moving the cutting machine or saw slowly to ensure that the tool doesn't over-spin, which might cause it to shut off due to overheating. Last but not least, take the necessary measures to minimize sawdust so that it doesn't interfere with your concrete cutting process.

Conclusion

In conclusion, there are several different methods of cutting concrete. The method you should use depends primarily on your specific concrete cutting requirement. For example, suppose you are unsure which method to choose or lack the knowledge and experience to make precise cuts. In that case, it is highly recommended that you hire professional concrete cutting Sydney (http://www.citycut.com.au/) services.